Factory reset Nortel Switch baystack 5520-48t-pwr

Resetting a stack using the UI button

The following procedure describes the steps to reset the stack using the UI button.

Resetting a stack using the UI button

The following procedure describes the steps to reset the stack using the UI button.

• Press and hold the UI button almost three seconds
• The unit is now in configuration mode. The color and status of the Status LED turns to blinking green.
• Press the UI button three times. The Base, Up, and Down LEDs will move to a blinking amber state and blink in unison.
• Press and hold the UI button for three seconds to confirm the command.

Please note that by factory resetting the switch you will loose all configuration settings. It will be as if it just arrived from the “factory”.

Follow these steps:

• Connect to the console port of the switch (9600,8,N,1)
• Reboot the switch.
• When the first line of the diagnostics tests is displayed, press CTRL-C. The system then displays a menu.
• Select option “i” to factory default the switch.
• Select option “a” to run the agent code.
• Upon boot up, the switch will be in a factory default configuration.